PRODUCT DEVELOPMENT AT THE PROBLEM SOLVER OFFERS!
AN EXCITING GAS CYLINDER REJUVENATION OPTION!

Chair Stuck????  Problem Solver can fix that!
Won't "lift" ???? Problem Solver can fix that!
Outta Gas????  Problem Solver can fix that
PUT NEW LIFE BACK INTO OLD CHAIRS!  Think Green!!!
...keep them out of  the landfill, while holding down equipment costs!

We offer a new line of replacement gas cylinders from most major manufacturers:
Herman Miller®, Steelcase, Haworth, Hon, Knoll, Allsteel, Global, United Chair, SC Leap Chairs, Aeron Chair Cylinders for A, B and C, Suspa Cylinders Globe Chair, Teknion and many more... 

New Gas cylinders are not always available for purchase on many chair models.                 
                                                                                         

A new tool developed to remove a gaslift cylinder from office chair base or from the swivel/tilt mechanism.  This WizBangOut tool will fit all standard office chairs. 
It is constructed of hard steel and built to take abuse.

Install the WizBangOut gaslift removal tool on the top part of the lift, as close as possible to the control.  (If chair is equipped with a telescopic cover, it can be taped to the five star base so it is out of the way.)

Apply lifting force to either the lift or to one of the legs at the five star base with
one hand. With the hammer in the other hand, give the gaslift removal tool several
solid hits on the flat part.  Always use safety glasses!

Instructions:

1)  Extend chair to the highest seating position,
     see fig.1.

2)  Turn chair to an upside down position,
      see fig. 2.

3)  Install the WizBangOut gaslift removal tool
     on the top part of the lift, as close as
     possible  to the control, see fig.3. 
     (If chair is equipped with a telescopic,
     it can be taped to the five star base, so it is
     out of the way.)

4)  Apply lifting force to either the lift or to one
     of the legs at the five star base, with one
     hand. With the hammer in the other hand,
     give the gaslift removal tool several solid
     hits, on the flat part, see fig.4. 
     Always use safety glasses.

If gaslift does not separate from control, apply
WD-40 where lift is embedded in control. Wait
approximately 20 minutes and repeat step 4.